Ultra-electronic Turbo User Manual download pdf (Page 30)

Quick Start Guide Ultra Electronics Card Systems

Page 30 MAGICARD TURBO Color Printer

4. Whilst changing the dye film, and with the dye film removed, gently wipe the tip of the

Thermal Printhead, using a gentle side-to-side action, with the Felt Tip Cleaning Pen

supplied.

5. Using a tissue, remove any deposits from the pen tip and replace the pen cap to avoid

solvent evaporation. Allow the solvent to evaporate fully from the printhead before

proceeding to fit the new roll of dye film.

Cleaning the Tacky Roller

NOTE - It is very important that these Cleaning Instructions are adhered to in order to

maintain the MagiCard print quality.

A Tacky Roller is located between the Cassette and the upper brushstrip. Its purpose is to

pick up loose debris, fibres and particles from the upper surface of each card which would

otherwise cause a blemish on the finished printed card. Depending on the type of cards

used it is recommended that the Tacky Roller is cleaned each time the Card Cassette is

filled, to recover its stickiness. Clean the Tacky Roller using a piece of Scotch adhesive

tape. Refer to Section E to see how to remove the Tacky Roller.

Cleaning the Rubber Rollers

It is recommended that the Rubber Rollers in the transport mechanism be cleaned after

every 1000 cards printed, using the recommended solvent-impregnated Cleaning Card as

follows:

CAUTION: Failure to clean the Rubber Rollers may result in mis-registration of images

and problems in feeding cards out of the Cassette.

WARNING The recommended cleaning materials are inflammable. Clean the Thermal

Printhead in a well-ventilated area and avoid naked flames. Extinguish any cigarettes.

Dye Film

Carrier

Dzus Fastener

Mechanism

Top Cover

Thermal

Printhead

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36 37

No comments

Ultra-electronic Turbo User Manual Page 30